Disadvantages of Progressive Lenses
It is limited in applicable range. Progressive multi-focus lenses have no limit in strength and can be worn for myopia, presbyopia, or moderate astigmatism, but they are not suitable for everyone. Now there are more than two categories of asymptotic focus lenses, one is hard and the other is soft. A person who can understand and adapt to the temporary discomfort that progressive multi-focus lenses begin to produce can have a pair of glasses. If you have severe symptoms such as high blood pressure, dizziness, or have a misunderstanding on progressive multiple focal lenses, and you are unwilling to adapt to them, it will be difficult to try.
How much do plano lenses cost?
If at big shop downtown, the price of the lens will exceed a hundred, but if you walk the campus store, will be a lot cheaper. Generally is 30-40 at least(not the poor quality, but the price is reasonable for students).UV protection, anti-fatigue, prevention of radiation, computer and television are the basic functions. In the campus store, it is several hundred or so, which can be matched with relatively good quality. Generally, the price of radiation-resistant resin lenses and frames is about 150. If you want to choose a better one, The price can be very high.
How to determine whether progressive lenses are worn correctly?
Once your glasses are back from the lab, the optometrist will let you put them on for an audition and make final adjustments to make sure they fit. If the prescription is not in the center of the lens, it will make it difficult for you to see clearly. The key is that the lenses match the wearer's eyes, especially the pupils. Before ordering a new lens, the optometrist takes two measurements: pupil distance and fitting height.
How do you identify the refractive index of lens?
In reality, this problem is often a problem for optical shop practitioners, sometimes they worry about whether the manufacturer's lenses match the nominal value of the refractive index. We need a prop, and that's the camber. Because it can be used to measure the strength of the lens. The luminosity of the lens can be calculated by subtracting the curvature of the inner and outer surfaces of the lens. The curvature difference of a lens of the same luminosity is inversely proportional to the refractive index, that is, a lens with a higher refractive index only needs a smaller curvature difference to achieve the same luminosity.
Each type of store has its own characteristics.
Nowadays, the optical stores in the market can be roughly divided into professional optometry and optical matching stores, fast fashion stores, brand flagship stores, and stores in shopping malls. The benefits of fast fashion optical stores are fast commodity update frequency, and they follow the fashion trend, which can bring consumers quite more choices. The size of fast fashion optical stores is usually not large, so they will use an open showcase design. The color collocation should be able to catch the attention of consumers, to attract customers to make self-service selection and experience.
The frame size has increased.
The larger the frame is, the more obvious it is now, so the edge glare will be more obvious when the lens is polished. It interferes with the visual effect. The frame height of the new glasses must be much larger than the height of the old glasses. Because when you buy big frame glasses, they must find out the pupil height when matching outfits. When you get glasses fitted at the opticians, the opticians don't measure the pupil height. That is, the balance line of the lens should be properly moved up when the lens is processed. If it is not moved up, it cannot be seen clearly.
Adjustment of the upper and lower position of the nose pad
The nose pad can be pulled up and down with the pliers of the nose pad to achieve the purpose. You can use needle-nose pliers to clamp on the nose pad and apply torque in a certain direction to change the upper and lower position of the nose pad. When applying the torque, the nose pad can be pressed down or pulled up by the pliers to change the position of the deformation of the bracket, to prevent repeated deformation and fracture near the solder joint.
